So I have been fighting trying to print a Lion model from thingiverse at

3D Printing
,
21

@Antonio_Hubbard sorry. My three year old would likely go ninja on you if you tried to pry it from him :slight_smile:

22

I did too. This and the 21 minute YouTube tour sold me. I printed that crazy gold fish on thingiverse with supports in pla and was able to remove the supports. I almost crapped.

23

@Joe_Spanier could you please link the vid?

24

@D_Rob this is the one that sold me: http://youtu.be/D968RL1Z6l4

25

Same here. Eric have you found anywhere to set acceleration like slicer?

26

@Joe_Spanier not yet. But I will poke around tonight.

27

I didn’t pay 140$ to mod my code :wink: but if it doesn’t work maybe I will make a feature request. Or adjust my firmware properly

28

Ohhhhhhhh well then. I’ll try that. That’s totally doable thank you! I haven’t gotten much time to play with s3d yet.