Norm_Dressler
Thu, 10 Jan 2019 21:21:25 +0000
GCodePrintr

Question - new to GcodePrintr but not to 3d printing. Long time user of Octoprint but it’s a pain with an RPI and the tablet presents a nice screen and looks good!
What I seem to be missing/not finding is the ability to manually send G codes in a terminal or console window? Is that available?
I have an ATX PSU connecting to a RAMPS 1.4 setup - I have enabled the Marlin firmware to accept the M80/M81 codes to turn off/on the ATX PSU - is there any power settings/plugins that can be used to turn on and off the PSU?
I also had an unusual problem when I tried to upload a file via the web interface, it fails - just goes to a dead page. Any idea what that might be from?

7 posts - 1 participant