JSY11
Sat, 01 Sep 2018 02:38:14 +0000
CNC Routers

I am trying to set up a laser on my OX, I have a gecko g540 with a UC300ETH-5LPT ethernet motion controller, running uccnc. I can control the on and off of the laser off the second output of the gecko and using the mist or M7 in uccnc. I am trying to get the pwm off of the gecko to control the power of the laser. I am using the spindle speed control to do this, but am having no luck. I have all the pins setup and if I check the pic low it gives me and output, so I know I have the right pin. I just can get it to work through a command.

Any thoughts

3 posts - 1 participant