Anyone recommend the best all metal hotend for a wanhao i3 touch / create

3D Printing
,
1

Anyone recommend the best all metal hotend for a wanhao i3 touch / create touch /maker select i3 pro etc… For printing higher temp materials?

2

Most people get the Micro Swiss upgrade these days I think.

3

Thanks +Ryan Carlyle
I was very close to getting a micro swiss but read a few bad reviews… Then I went into analysis paralysis haha
Now I just can’t make my mind up

4

It’s good, but not magical. A wholesale swap out to an E3Dv6 is better than swapping out half the stock parts. But the Micro Swiss sits at a good compromise between rework effort and performance improvement.