Baxter the robot picking up a Bukito 3D Printer!
Are you part of Baxters engineering team or what’s the story behind him?
I had a booth next to Mitsubishi and AHP who own a Baxter. Fun times. Edit: If you don’t feel this is relevant to this community @ThantiK , I can move it to the Deezmaker community.
@Ben_Van_Den_Broeck nah, totally relevant. 3D printers are robots after all! And there’s certainly a Bukito in the pictures! 
OK, now I want to see him get a print off it.
Put a 3d Pen in Baxter’s gripper and make him print.
That will not be a problem. Look up the video of a Bukito printing while whizzing around under a drone.
it’s hard work.
Ha. Missed a good opportunity to have Baxter unload a plate and repeat prints.
I wish I had more time to play with Baxter due to the popularity of my booth. These photos were taken after the open house. My laptop was attached to the scanner so I’d have to rely on an SD card + a lipo to print anything on it. 20 minutes of “programming” would have had Baxter place the printer in front of him, grab a spool, hit print then flip the Bukito upside mid-print. But nope, I only had ~3 minutes 
You should invite him over to your shop! 