Big thanks for a great Software! Installed LaserWeb3 on an Raspberry Pi 3 last

CAD & CAM Tool Chain LaserWeb/CNCWeb
,
1

Big thanks for a great Software!

Installed LaserWeb3 on an Raspberry Pi 3 last friday and had first results on my 3d-printed cnc machine.

PS: I allready searched the existing entries to find some recomandations regarding raster engraving settings (15 watt diode laser on 4mm plywood) but couldn’t find one. Can someone point me in the right direction?

Regards
Stefan

b428bc0a2e57b16bf51e30084f5e040a.jpeg
b428bc0a2e57b16bf51e30084f5e040a.jpeg4608×3456 3.29 MB

4221c0ae69d76f78c04545c0ca40d9fa.png
4221c0ae69d76f78c04545c0ca40d9fa.png1844×928 117 KB

fedd7e6b4fa684e4c4ed758c7f7a0904.png
fedd7e6b4fa684e4c4ed758c7f7a0904.png1844×928 122 KB

0369692e151bce58e9d010280c3b1b81.png
0369692e151bce58e9d010280c3b1b81.png1844×928 125 KB

5f015b0170864a248c3d990f89eca615.png
5f015b0170864a248c3d990f89eca615.png1844×928 125 KB

341a3811be52024735d95499104784f0.png
341a3811be52024735d95499104784f0.png1844×928 134 KB

b99dd54e449c7091ed3a771b157f073a.png
b99dd54e449c7091ed3a771b157f073a.png1844×928 128 KB

2

+Peter van der Walt: I asume it’s the same setup procedure, just a different url for the “git clone” statement. right?

3

+Peter van der Walt: Got it up and running! Thanks!
BTW: the gcode generator of the rasterizer does not issue an M3 command by default, must be added to the gcode section of the settings to “gcode start”. Seemed to be different with LW3