I cannot find out why my “home all” command moves just 10mm at a time and does not go all the way to the endstops. Could someone suggest possible places I might look in the config for conflicts? It is a Smoothieboard for a delta. Everything else works, but I can’t print if I can’t get home to configure. No probe, manual configuration. TIA
Imported from wikidot
This sounds very much like your endstops are not properly wired, or inverted.
What does M119 report when the endstops are triggered, and what does it report when they are not triggered ?
M119 gives these responses: “1” for down, “0” for home (to max)
Ok they are inverted. You need to invert your endstop pins in configuration, see the “endstops” and “configuration” pages