G32 on Delta- Effector bumping near towers when probing.

Controllers Smoothie
1

Hello everyone. I have not touched my printer for a month and a half and I forgot a lot of things about the fw, I am having a weird issue when I give the G32 command. When G32 command is issued, the nozzle comes down at the center then probes and then moves far from the bed (near tower) to probe another point and so on. I have tried reducing the “leveling-strategy.delta-calibration.radius” to 40 (bed is 200 mm diameter) but didn’t work. Am I missing something here? I would really appreciate your help, thanks.

Imported from wikidot

2

Do you have a config-override file ?

3

Nope, just the config and the fw.

4

Try formatting the SD card, and starting from a fresh configuration file.

5

Hi Arthur,
Thanks for the suggestions. I overlooked it and figured out that the Calibration strategy was commented. But now I see that you have updated the fw and I think the Grid leveling strategy is new. I read in one of your old comment that both Calibration and Grid strategy cannot be used at the same time, is that still true? Thanks.

6

They can be used at the same time