HALT issue with heated bed

Controllers Smoothie
1

I’m getting the HALT asserted error below. The problem is that the bed is at temperature as you can see from the line above. This causes every print to fail. I am using Edge on an MKS SBase board

READ: ok T:240.0 /240.0 @96 B:60.5 /60.0 @0
SENT: M105
READ: ok T:240.2 /240.0 @85 B:60.4 /60.0 @0
READ: ERROR: Temperature took too long to be reached on B, HALT asserted, TURN POWER OFF IMMEDIATELY - reset or M999 required
SENT: M105
READ: ok T:239.9 /0.0 @0 B:60.4 /0.0 @0
SENT: M105
READ: ok T:238.5 /0.0 @0 B:60.4 /0.0 @0

Imported from wikidot

2

Hi.

For any MKS board, we respectfully request that you contact MKS for help. Their product is toxic to the Smoothie project, and we can not reasonably be expected to help destroy ourselves.
If MKS is not able to help you, you are welcome to ask for help here then, though many would refuse to help even then.
Hope you understand.

Cheers.