Hello everyone! I am nearly complete on my configuration of the new Kamikaze 2.0.8

3D Printing
,
1

Hello everyone!

I am nearly complete on my configuration of the new Kamikaze 2.0.8 version. Only outstanding item so far, is where do the traditional Z probe get plugged into? I have a micro switch on the end of my delta nozzle.

Thanks,
Jim

(looking forward to printing this weekend)

2

If your probe requires 12V, put it in the Z2 connector. If not (microswiches usually don’t) you can use which ever end stop input is free. You have to configure it in software anyways!