Hello, I cant seem to find the answer Im looking for.

CAD & CAM Tool Chain LaserWeb/CNCWeb
,
1

Hello, I cant seem to find the answer Im looking for. I have an eleksmaker with grbl1.1e and Im trying to use laserweb4 on linux.
I can load the gerber and start the job but the laser is not powering up. Is there a setting I need to change/set to enable the laser?
I dont know much about g-code and Im barely starting.
Thanks

2

@Daniel_Esparza ​ make sure your firmware and LW settings match. Please read this