Hello. New to the 3D Printing thing and I've assembled a FT Kossel kit

3D Printing
,
1

Hello. New to the 3D Printing thing and I’ve assembled a FT Kossel kit and replacing the RAMPs with the Replicape and repurposed BBB. I’ve re-assembled the stepper motor cables to be in alignment with the image on the wiki.

I’m having more difficulty determining the wire placement for the end-stops. The cables were wired straight through for the RAMPs but the image indicates the middle and an outer wire swap places. How do tell which wire goes where?

2

bah! Scroll down and RTFM some more and there’s the answer. never mind.