Here is a video of an airflow test of my new enclosure(btw,

3D Printing
,
1

Here is a video of an airflow test of my new enclosure(btw, it was a lot of fun):


The extruder tip is plugged. That’s why it’s torn down a little.

2

Just curious, but isn’t that a condensation risk? It would suck if condensation damaged the circuit boards or something.

3

@NathanielStenzel I suppose it would be a risk if I had left it going for a long enough period of time for condensation to build-up on the circuit boards… But then the boards would have to be dirty enough to make the water conductive enough in just the right spots to create the short.