Hi Guys!
I’m new around here but i found this community great 
I am currently working with Zonestar P802M (Prusa i3) and I hope I can get your help with an issue i experienced. i have decided to upgrade my melzi controller board to fastbot bbp1s
The Fastbot controller runs Octoprint which is amazing but also very frustrating because there are so many advanced configuration i dont know how to configure and it damages the prints heavily. here are some things:
- Extruder is working “too fast” - after 1-2 minute of printing standard pla, every seconds of extrusion the extruder hiccups once (like it cannot push down the filament) and then continues until the next one
- the printer becomes faster as printing time continues (believe me it becomes very very scary, you could swear things will start flying in the air)
- there are inconsistencies with the extrusion of the PLA - most probably due to the speed of the system.
- the 3d printer has a size of 220x220x220 - when i put a file in the middle of the bed, it still starts 30-40% to the left
can anyone help translating the old configuration to the new one (they are based on Repetier-Firmware V0.92 and can be found here:
http://pastebin.com/8DYKSKGj
Thanks!!
Hila