hi, having some trouble with the reprapdiscount display.

3D Printing
,
1

hi, having some trouble with the reprapdiscount display.
well, it’s not that it isn’t working or freezing, not that unlucky BUT: i’m using repetier firmware (cause it’s easy to configure and to modify) and the encoder not only turns the other way (decreasing values clockwise) - which i can get over, but it scrolls 2-3 elements per “step”. where can i make changes to get it to work properly?
Thanks to anyone who can bring some aid

2

@Thomas_Sanladerer did a video on an LCD not too long ago. In this video he describes how to set the encoder direction and sensitivity. Check him out on YouTube. Lots of great information.

3

yeah, I’ve seen BUT ( :stuck_out_tongue: ) i’m not using Marlin and repetier is vaaary different when it comes to the conf and pin files. not to mention the displayed menu. I was hoping someone using this firmware had some insight