I believe that I have accomplished 99% of the design for the    

3D Printing
, , , ,
1

I believe that I have accomplished 99% of the design for the #SCOUTcorexy reprap #3dprinter that I have been posting about in the past weeks so I’ll post again for opinions or last minute observations/concerns/etc.

I still have to put the endstops and the bowden extruders in the design but about everything else is there (I hope).

I have uploaded the STL to Sketchfab (click on thumbnail below) for easy viewing and I have also started a Wiki page @ SCOUTcorexy - RepRap

All the #3dprinted parts (floating) are attached to a STL @ SCOUTcorexy 3D Printer (square aluminum tube frame, scout-tower-like corner nodes, dual-support Z, lots of adjustability to compensate for construction errors) by florinf-ro - Thingiverse so #3dprinting them should be easy.

Thanks.