I finally got around to uploading a video of my first attempt at 3D Printed

3D Printing
,
1

I finally got around to uploading a video of my first attempt at 3D Printed RC boat.
http://www.youtube.com/watch?v=eXW2j5P7SF4

2

cool

3

Runs very nicely! Congrats :slight_smile:

4

@Shauki It was printed as 20 sections, each representing 30mm of the hull, yielding a total length of about 600mm. It is printed in ABS, so its not affected by water.

5

@Shauki Ah yes, I see what you mean. Yes it was close to 100%. The hull thickness is 3mm.