I had a crappy day today. As I was cutting I noticed that I never tighten one of the bolts down ofcourse in doing so I threw the whole thing off and I am having to start over aligning the thing again and just as I had it about tuned in I went to move the table it was sitting on closer to my old dryer vent when I did that the top of the table came off (I was to lazy to screw it back down when I moved). I barely caught most of the weight before it hit the ground from what I can tell nothing broke but I haven’t got it hooked back up yet to see
Omg! Hope it survived!
Some days it’s just better to stay in bed 
Good news laser still fires bad news back to square one for alignment 
Whew
I am glad it is still working.