I hate it when the wife decides to learn all aspects of 3d printing. Then when you have her actually go through the steps of turning it on -> printing something and the machine doesn’t respond. I mean nothing. Now my weekend is here and I’m suppose to rip apart the wires and reconnect them to get it working.
Before all that I decide to try to start it again and remembered the light (on the same surge-protector stick as machine) didn’t work also. So I checked to see if it was plugged in, it was. Next was to flip the switch on it and !!! it worked.
1st lesson to my wife - make sure everything is plugged in and all switches are flipped on when starting the machine.
(sry this was so long :P).