I have completed the write up for my Shapeoko 3 Enclosure,

General CNC CNC Routers
,
1

I have completed the write up for my Shapeoko 3 Enclosure, please give it a read :slight_smile:
http://www.makealittlemore.co.uk/2016/02/10/diy-cnc-router-enclosure/

2

Nice. I like the design. I’ve been looking at various diy designs for a whip now and this is so far the winner.

3

Whip = while :slight_smile:

4

Thanks! If you go down the route I did prepare for the long haul! it takes a while to get it right :slight_smile:

5

Awesome work !!

6

I don’t know if I could handle the machine down by my feet instead of my waist.

7

It’s not too bad, when I get a new workshop I’m definitely going to raise it to waste height though