i have the blue K40 using the unmodified controller.

Lasers
,
1

i have the blue K40 using the unmodified controller. i have the unit cutting properly but now i am trying to etch and cut but the etching comes out about 1/10 the side it is suppose to. and i cant figure out why.

any ideas how to get the etching to the right size?

2

Make sure under, coreldraw settings, that both “Engrave Data” and “Cut Data” are set to WMF.

3

I’m assuming that you are using coreldraw but if it’s laserdraw I think the same thing applies.

4

thank you i would have never figured that out

5

Welcome. Let us know whether or not that fixes your issue.

6

sorry engraving now. and yes it worked