I just noticed that GCodeSimulator V1.59 was still in beta test,

3D Printing GCodePrintr
, ,
1

I just noticed that GCodeSimulator V1.59 was still in beta test, even so I had released GCodePrintr V1.59 already 2 weeks ago… anyway I pushed it to production as well.

2

All of my axis are working fine except beta (y). It only turns in one direction even after homing. What can I check? I replaced the stepper motor. Thanks!

3

I am using a smoothie board.

4

I had a similar problem once when my endstop cable was loose. I guess its not a software problem, or does it work with other host software ?

5

I swapped end stop cables but it stayed with y. I will ask smoothie board. Perhaps its a config problem. Thanks.