I was trying to find the pros and cons of using a capacitive sensor instead of an inductive one, however have not been able to find anything that I could trust.
I remember reading somewhere that the capacitive sensor is not as accurate. But not sure.
I have a glass bed, so cannot use the inductive sensor.
Does anyone on the group have any personal experience.
Just buy some foil tape to but below your glass bed.
That’s what I was doing - but didn’t work too well. Was getting different distances at different points on the bed.
@Ross_Bagley what’s an fsr??
Hmmmm. Will try that
What about the bltouch? I have not used it yet, but it looks interesting.
Cost is a deterrent there.
Bltouch is fantastic.
Never seen bltouch before but it looks very promising after a cursory investigation.