I'm finally printing the last few bits for an i3 (original) and I'm not

3D Printing
, , ,
1

I’m finally printing the last few bits for an i3 (original) and I’m not sure which extruder to use with a jhead nozzle. Recommendations?

2

I put a compact extruder on mine and I’ve had good experiences so far.

3

I went with a direct drive bowden, but that’s about to be changed to a dual qu-bd bowden.

4

I’m about to be using the gregs-wade-v3 out of the Prusa3 repository under extras. It has to be spaced quite far from the carriage though. My experience was documented here: https://plus.google.com/u/0/+TonyOlivo/posts/Fdbbwc2AccA

5

Thanks for the info guys. I’m going to try and get something printed this afternoon.

6

Any success with the direct drive variants?

7

Sorry, forgot to post a link of the one I used: http://www.thingiverse.com/thing:26817

8

@ThantiK whats the dual one your thinking of? I am tempted to go dual too.

9

@Daniel_Wood something experimental I’m piecing together out of the parts that DeltaMaker uses.