I’m still amazed by the smoothness of a print on the Ultimaker. This is silver PLA at 0.1mm layer height (the ‘normal’ quality setting).
Impressive!
The fact that you call .1 mm the normal setting speaks volumes for your build quality. Can’t help but be a tad jealous.
It’s called ‘normal quality’ in Cura 
The ‘high quality’ setting is set to 0.06 mm.
Ah, gotcha
You’re right, but then again normal for the Ultimaker is everyone else’s awesome! Awesome for the Ultimaker is just unobtainable dream!
Hey @Erik_de_Bruijn isn’t that right?!?
There is also an “ultra” setting, however that is only available when you know how to print really good quality prints
you already do, the answer is within you
Man I regret not getting an Ultimaker big time
@Hal_Gottfried_Hal900 I guess if the customer gets this quality, we’re happy. Not that there isn’t room for improvement…
No need to regret, @Spenser_Lee . B.t.w. did you know we ship from stock nowadays?
@Erik_de_Bruijn haha I’d purchase one in a heartbeat if I had the money
@Erik_de_Bruijn haha I’d purchase one in a heartbeat if I had the money