I’m thinking about getting a Folger Tech Cloner - Dual Extruder 3D Printer Kit, for my 1st 3d printer. Is this a good choice for dual extruder and multiple filament type that I could use? I’ve been reading and looking at videos on it about the heated bed, some cons & some pros on it and it seems really iffy since the support team of it isn’t really there at the time of the posts I’ve been reading from the forms and some of them also said that some of the parts came manufactured wrong. And also since the nozzle yeah I believe stated to heat up around 230 is that hot enough for some of the Exotic filaments
Got a folger tech delta. Very pleased with it. Superb quality and good support. Mine arrived with a stepper motor missing. Support awnserd my mail directly and got a new one within a week, no questions asked. ^_^ have been running my hotend at 260 degrees without problem. Have added cardboard beneath the heatbed to get faster heating time and a more stable temperature.
Have you tryed any exotic filaments
No, I only print in ABS for now. But I have some flexible filament that I will try later on. But as it is a bowden setup I will have to print extra slowly. I am considering building a new 3d printer with direct drive to print exotic filaments.
Yeah I can understand the bowling setup is so far really good one to have because I seen a couple of videos people did the Boeing set up to the to the cloner and they it runs alot smoother