I've been trying this guy out for the last couple of weeks and I

3D Printing
,
1

I’ve been trying this guy out for the last couple of weeks and I have to say, it beat my expectations by a fair amount :slight_smile:
http://makerhacks.com/creality-cr-10-3-dprinter-review/

2

So… I’ve never heard of that Zebra mat before… I’d love to hear from other people if they think it’s worth the ~$42 to upgrade an i3 clone with it.

3

also, great review :slight_smile:

4

I actually prefer PEI over Zebra, the main reason I went for Zebra on this guy is I knew I was going to have a lot of large, stubborn prints in my future, and the zebra allows you to remove the plate and flex it to pop prints off instead of going at it with a scraper :slight_smile:

5

PEI is my go to. I agree about the lack of removability but for the quality tack it has and life cycle, it’s well worth it.

6

Is that an extended wanhao?

7

No it’s based on aluminium extrusion but has the same PSU case :slight_smile:

8

Check n-ways as much as whether ty!?