LaserWeb3 Help! I am seeking settings that have been tested by others as correct

Lasers
,
1

LaserWeb3 Help!
I am seeking settings that have been tested by others as correct and functional.

Today- I Installed Scott’s ACR/Smoothie/Supplemental power kit, rechecked my connections, and fired it up. I accessed Laserweb3 and inserted some settings that I found online. G28 Start, M1 start laser, M5 stop laser, M5&G28 endcode. Laser diameter- 0.1, and finally bed area of 200x300. Machine powered up fine, laser homes to top left (just as stock m2Nano did).

The machine was ending out by attempting to go further up when I ran a test print without laser on.

First, I would appreciate if your would share your Laserweb3 settings with me, and how functional they are.

Second, I would like your opinion s to whether this could be a software setting issue, or a incorrectly wired stepper motor.

Thank you for your help!!!

2

@Matthew_Prater ​​ laser On is G1 laser Off is G0.

3

@Ariel_Yahni_UniKpty thanks for responding, however I’m not sure what you are saying. Could your rephrase so that I can better understand?

4

I’m beginning to think that my stepper motor is wired backwards. The home on LaserWeb3 is 0,0, however my machine is homing at 0,200 (or the upper left hand corner).

5

@Matthew_Prater ​ I fixed the typo above. Laserweb should home to max so upper left. Still 0,0 will be lower left

6

Bed area should be 300x200 ‘x’ axis is first then ‘y’ and in settings/tool place uploaded image in quadrant top left this is normal

7

Thx Peter

8

Awesome! Any word on when LaserWeb4 will be ready to use?