LPCXpresso

Controllers Smoothie
1

Hi at all, I’m new to this community
Many thanks to all of you that contributes to mantain this software and hardware…
Sorry for my poor english.
I’m not new to 3D printing world and i wish to turn from Arduino to Smoothie world
I’ve try to install Boot loader in my LPCXPresso 1769 in breadboard (new version rev D) with mac OSX and lpc21isp method.
All seems ok and flashing goes to fine … but when reboot with SD card connected and firmware.bin - config.txt inside, nothing appare.
Firmware and config stay in SD and no activity on board.
Then I have try with other system, in windows with FlashMagic . Also whis this all seems ok with no error on flashing but same result.
I have change SD card reader but no works, All SD cards working at well with Arduino…
Seems that Bootloader it’s not working with this PLC…
Do you have any idea pls?
tks
Marco

Imported from wikidot

2

Do you still have the lpclink attached or did you saw it off ?

3

Thank you Arthur for your fast reply :slight_smile:
the lpclink its sawed from the board
I have follow rigidly the instructions from your site ‘smoothie from breadboard’
Connection are been controlled and tested with multimeter.
LPCXPresso is rev. D (LPCXPRESSO1769 WITH CMSIS-DAP)
That’s not the version marked on article, it’s the new one…
LPC Board its working fine
Maybe Bootloader is not compatible?

4

This one:flickr:32855640402

Has Reset and ISP on board