Martinez Board Brushless Gimbal V3.0 Controller with Sensor price: $59.99 #CameraGimbals
This seems quite pricey considering you can get them from hobbyking for about 30usd.
These boards are just an atmega chip, an ftdi for USB to serial and two triple half-bridge chips right? I wonder if it could be done cheaper with some mosfets and not bothering with on board USB (USB to serial adapters are like $3). The IMU boards very cheap on ebay/dx.
Where can I get the BOM and source for this board?
In with you on that the kk2 board has the gimbal feature built in does it not?
@Cain_Blank interesting, I think that uses the IMU for the Quadcopter to try and stabilise the camera, rather than the camera having its own IMU right? And I doubt it has the brushless drivers built in like this, probably just has servo outputs. I wonder if it works as well?
Hi @Jackson_Linam . Thanks for your comment. Yes, this Martinez Board Controller seems a little bit expensive. Now we offer a special price for $45.00. We sell it direct from our factory, it has one year warranty and 100% full manufacture warranty. And we have a strict quality control and we think it is valued to highly recommend.