Maybe someone can use this information when building a CNC controller using USB…
Originally shared by RoboCNC Frees- & Graveerwerk
RoboCNC USB Controller full info link…
Now including schematics…
#RoboCNC #RoboElectronics cnc #Freeswerk #Graveerwerk
Why is it named “USB Controller” when it has a “25 pin D-sub connector”?
Marcus maybe taking a few minutes to read the text would explain that part. I post this to help people out who can use this information. Comments like this are pretty much useless and not appreciated at all.
And of course I even want to help you, so you do not have to take the time to read it, so:
The 25pin dsub connector is a breakout board for ease of connecting the wires to the USBCNC board. (The board that accepts the USB port FROM the computer).
@RoboCNC_Frees_Gravee By “Comments like this are pretty much useless and not appreciated at all” , I assume you mean your comment. Because in this community it is not. In my experience there are no bad questions, And you’ll have to forgive one for not feeling the need to hang on every word of your spamming post.
And good luck with your sales technique there. I’m sure $hit draws a lot of flys where you come from…
@Mat_Helm Thanks for you input… For your information, I do not sell any of this, I only take the effort to describe this DIY controller, make free drawings and schematics, make free video’s and try to explain (again for free) how I have done this job, and with what parts.
I do not ask for anything, and nobody has to thank me, If you do not appreciate the effort i take to make this available for free you can just ignore it.
Asking any question is fine, and again I would try to explain everything, but i do not stay silent If someone does not take the effort in reading it and makes a comment to make fun of me.
Again excuse me for posting this information on this community to you and Marcus. I will not do so again.