New analog panel on FL-K40D

Lasers
2

Hello Don, thanks for all the knowledge you are sharing.
I tried doing my own wiring, but something its wrong. I can set the desire power manually by adjusting the pot, but when i sent the command on the K40 whisperer to raster engrave, I do not get enough laser power on the material.

K40 diagram
K40 diagram1056×816 102 KB
Not sure what its wrong. Here is a copy of my diagram. Can you please take a look? Do you see anything wrong?
(Tube, LPS, PSU, Pot, Switches, M2 Nano board, Laser Tube, Digital Voltmeter are brand new).

1 Like