Playing with endstops on my CNC, smoothie and laserweb3.

CAD & CAM Tool Chain LaserWeb/CNCWeb
,
1

Playing with endstops on my CNC, smoothie and laserweb3.

After a limit is detected, smoothie goes to halt and ask for a reset or M999.
However LW3 stop sending anything to the board, even the m999. LW3 is connected, display the alarm state. Tried to closed/restore the connection, still doesn’t send the m999

Is there a way to recover from the halt state via serial link or the hard reset is the way to go ? Or LW3 issue ?

@Arthur_Wolf

2

@Maxime_Favre I think somebody should teach LW3 to open a dialog that allows sending M999 when an error is detected.In the meantime a hard reset will work.

3

If you have the kill button hooked up then holding it for > 2 seconds will also clear the halt condition.