Printed with 1mm nozzle and 0.8mm layer.
http://www.3dbenchy.com/thick-layered-transparent-3dbenchy/
http://www.3dbenchy.com/thick-layered-transparent-3dbenchy
Nice material! I wonder what Superman’s Fortress of Solitude would look like printed.
That is gorgeous! I can never get my PETG to print that clear.
This looks strangely beautiful…
Very impressive. It looks better than glass.
+Justin Morel Inspired by these photos, I played with my old transparent PETG, stuff I set aside a couple years ago because of my initial troubles. I think it had too much moisture in the first place, it had tiny bubbles on extrusion back then. Drying it out I was able to get much better results.