Printing goes sideways

Controllers Smoothie
1

Hi Forum,
after some printing last week my ali-express diy Kossel mini kit that i upgraded with an azteeg x5 mini v3 started getting an offset away from the alpha tower(or x tower how you like it). So all my prints just look weirdly shifted in one direction.
I thought that it maybe was a problem with the calibration (i tried everything else that came to my mind) and while calibrating the printer manually i noticed when i for instance moved from the beta tower straight to the alpha tower without homing inbetween the z position is easily 2mm lower than when i home the printer before.
Also has someone tried the network features on the azteeg I can’t figure out how to get them working.
Thanks in advance for answering

Imported from wikidot

2

Check if the pulley’s screw is tightened enough, and if the belt is tight enough.

3

Thanks Arthur
Yes it was either the pulley or the belt i’m not 100% sure but now it works.
Do you happen to know anything about the network stuff with the azteeg because there is the presoldered network jack but i can’t find the settings to activate it in the config