Printrbot autolevelling...this video is cool from an autolevelling standpoint...but their experience with the first

3D Printing
,
1

Printrbot autolevelling…this video is cool from an autolevelling standpoint…but their experience with the first layer or two not sticking, then adjusting the heat sure would have made me feel better with my first prints!
http://www.youtube.com/watch?v=H0I4833mPC4

2

How did you calibrate the autoleveling. I want to try it.

3

I didn’t, I think the folks at printrbot did, check the comments on the YouTube page.