The first print passes normally, both through an octoprint, and from a flash card.
SECOND PRINT, without rebooting the printer - the warm-up starts normally, the table is warmed up and the first extruder is expected to warm up. As soon as the table is warmed up - the second extruder is turned on, the second notend is warming up and the printing is the second nozzle !!!
If the printer completely reboots between the prints, everything is OK !!
The first print ALWAYS goes normally - the second one without restarting the printer - spontaneous inclusion of the second Notand and the Second extruder!
In Gcode created by CURA 15.04 there is no mention of either T1 or T0!
Before that, all the printers printed normally ….
Imported from wikidot