So it's been a bit of time since I published the Umikaze 2.1.1 image.

3D Printing
,
1

So it’s been a bit of time since I published the Umikaze 2.1.1 image.

Many on Slack have reported good things, some have reported a few issues which we’ve tried hard to fix and have turned out to not be a problem in the image per se.

That said, the development team takes the feedback of the Replicape community seriously, and I thought it’d be interesting to get a feel for how the community feels about the development team in general, and whether things are working fine, or do we need to spend more effort getting the message out there.

The form below is 6 questions and completely anonymous, so if you can take the time, we’d appreciate hearing back from you.

Sincerely, the Replicape development team

2

Hi Jon!
Is it possible to know the results of the feedback from community?

3

Sure! Though community feedback feels like a bit of a stretch at this point, we only have 8 or 9 answers in the sheet as of today’s… I’ll post the read only link here as soon as my self inflicted fresh hot glue injury stops throbbing :wink:

4

Here it is. Since answers are anonymous I think it’s ok to make them public?