So ive got two prusa i3 printers and have only been using one of

3D Printing
, , ,
1

So ive got two prusa i3 printers and have only been using one of them. I am thinking of stripping my spare printer and building a different printer with its electronics. It runs on ramps 1.4 and i believe has nema 17 motors. Any suggestions on what to build???

2

Is there an i3 design with NEMA 23 motors?

3

if not 23 then 17’s. No im second guessing ive going to the garage to check

4

Thanks Jeff you were right! I edited my post

5

What Delta did you go with @Alex_Lee

6

Build a delta… Kossel type

7

mendelmax 1.5+