So near the end of my R7 build and looking for some ideas for

General CNC CNC Routers
,
1

So near the end of my R7 build and looking for some ideas for the control box and wiring coming out of it. Anyone willing to share their solution? Anyone willing to share wiring diagrams?
Thanks
A…

2

Please tag me in any specific questions. The wiring is a lot more simple than you think. Use shielded wire and a shielded serial cable. The spindle makes a lot of RF noise.

3

Seems a couple of guys put up wiring diagrams in the beginning. I think they may still be in the R7 site.
I know there’s a few images in this community somewhere as well.

4

@Brandon_Satterfield here are those that Scott (I think) made a while back.

https://drive.google.com/file/d/0B-mg8IWQF1PkNjZMZEltQU1XV3M/view?usp=drivesdk

https://drive.google.com/file/d/0B-mg8IWQF1PkUWpEeUNVS0tkOGc/view?usp=drivesdk

5

The manual had me set up the Tiny-G with servo-1 as X. If you follow the diagram here make sure to tell the Tiny-G where your servos are.