#Solved, i had to set my gamma_max to 350 - it was 0
Hi all,
i´m trying to install a bltouch to my corexy but i can´t get the probing to work. My Problem is, that G30 immediately returns “READ: ZProbe not triggered” without even trying to move z-position.
I configured endstops for x and y to max and z endstop to min. Homing runs fine
this are the commands i use for a simple g30 probe
M280 S7.0
G28
G1 Z10
M280 S3.0
G0 X200Y200
G4 P6000
G30
I tried a lot but i can´t find an error. Can it be a firmware error on corexy? I´m using latest stable.
And sorry i can´t provide links to configs cause of low carma ^^
Imported from wikidot