Temp sensor detection issue

Controllers Smoothie
1

Hi All,

I replaced heater block to volcano and looks like wires from thermoresistor not enough long - one of them unsoldered, when i back after ~1.5-2 hours I noticed that plastic extruder chops plastic and can not push, then I touched the heater it was cold, but the printing dont stopped…… I removed capton and one of thermoresistor wires was on capton…….
I think this is bug, i am using smoothiebord like a year with cheap v5 and v6 hotends and all was fine before volcano….

TY.
WBR,
Andrew

Imported from wikidot

2

For Smoothie to detect events like this you need to enable the temperature runaway detection feature, see the temperaturecontrol documentation on smoothieware.org