The new engraver came in today…
Damn it’s sweet, did some testing…the alignment is dead on.
That’s the Shit ! Merry X-mas to you !
That looks like it’s actually built much better than the K40s, even though I assume it is similar manufacturer. Great holiday present to yourself 
Have fun.
Thanks guys…I hope everyone has a merry Christmas!
Nice! Where did you source it?
Amazon…andyking company…it has a 50 watt reci tube…nice man…everything came perfectly aligned.
Yup
In the photo it looks like a motor attached to the table? The similar models on ebay show the same setup, but state “manual up down table”. I wondered if the Chinese description of manual was different than mine (as some of their descriptions when translated are). Is it motorized by switch or panel control or can/must you adjust the height by turning the knob on top? (or both).
Push buttons on the side for up and down.
@Coherent I imagine that “Manual” refers to you needing to press the buttons Up/Down in order to get it to go up or down, rather than being automatically controlled by software. Chinese translations are difficult to read, yet sometimes amusing.