Tip of the day Adjust the print speed during print just by pressing

3D Printing GCodePrintr
, ,
1

gcodeprintr Tip of the day Adjust the print speed during print just by pressing the extrude/retract buttons. Extrude(+) button will increase the speed by 10%, Retract(-) button will decrease the speed by 10% .
This allows you to manually slow down critical areas and speed up when needed.
btw. next version of GCodePrintr will allow to configure the percent steps.

0c7b883acf0a591c63e8fce0b7cf9ea8.png

2

Can these icons change between the running ‘speed’ mode and the paused ‘extrude’ mode so it’s more obvious that is what happens?