We’re #3Dprinting the same part on two commercial printers for #ThingiThursday this week. Will report on the results later on, the UP! didn’t fancy doing all of the raft, don’t think the bed is level.
Spoke to soon, UP ended in disaster. FAIL
Bahahaha. stupid Up.
Please note that proper calibration is just as important as the machine itself. You can try to compare 2 different machines, but if one is calibrated better than the other, then there will be obvious differences in quality.
It is usually calibrated perfectly and we’ve had lots of very successful prints from the UP! but today it didn’t seem to be playing ball. It needs a bit of an overhaul.
i have up printer and it dont print nice the bottom part of the ball
oh! what happened?