Hello,
I’ve set up my Grid compensation at 13 X 13. I get all my points, I save with M374, but then when I recall grid with G31, It gives me this:
X0 A45.00 B3.51 C3.56 D3.45 E2.98
X1 A2.61 B2.63 C2.68 D2.44 E0.93
X2 A1.28 B1.85 C2.23 D2.44 E2.49
X3 A2.88 B3.30 C2.76 D2.35 E2.32
X4 A2.20 B1.02 C0.23 D1.42 E2.12
I’ve looked at the file, and it starts with 45, and then lists all the points down the list, no letters or anything. Did something go awry when saving, is there an example file I can look at? Any help would be appreciated. I’m doing this on a very large printer, and it would save me some time to just write out anything that is missing.
-Austin
Imported from wikidot
(Tired and didn’t plot out what I did correctly)
M374 to save, M375 to recall, and G31 to spit it out to me.
The last File it saved out:
40
3.660
3.725
3.530
3.000
2.730
2.730
2.565
2.370
1.665
2.060
2.515
2.855
3.185
3.550
3.590
3.350
2.755
2.435
2.460
2.345
2.130
1.325
1.690
2.140
2.510
2.955
3.425
3.460
3.175
2.520
2.165
2.170
2.035
2.000
0.965
1.320
1.815
2.230
2.740
3.290
3.395
3.105
2.370
1.990
2.030
1.995
1.910
0.690
1.045
1.495
1.900
2.425
3.055
3.310
3.015
2.235
1.830
1.865
1.890
1.900
0.400
0.690
1.160
1.585
2.120
2.730
3.140
3.110
2.365
1.880
1.900
1.975
1.955
0.000
0.290
0.745
1.100
1.575
2.180
2.605
2.925
2.365
1.835
1.785
1.910 # these segments. Smaller values mean more resolution,
# higher values mean faster computation
- Arm solution configuration : Cartesian robot. Translates mm positions into stepper positions
alpha_steps_per_mm 160 # Steps per mm for alpha stepper
beta_steps_per_mm 160 # Steps per mm for beta stepper
gamma_steps_per_mm
1.980