Z-probe offset

Controllers Smoothie
1

My Z-probe is about 30 mm to the right of the nozzle and triggers when the nozzle is about 1.9mm above the bed. Does that mean that its offset in the config file (leveling-strategy.three-point-leveling.probe_offsets) should be 30,0,1.9 or 30,0,-1.9? I can’t find the information anywhere on the Z-probe page.

Imported from wikidot

2

Don’t use the offset that way.

Just keep the value at 0 for Z, and then use M306 etc to set the height above the bed.